"Talk about weaving two or three things - about the maintenance and cleaning of wool hand-knitted clothes - 2 tragic examples 1"
The previous article shared with you some wool hand-woven maintenance and cleaning tips, thank you for not complaining about my logic, I looked back and read it many times, there are actually breakpoints, some explanations seem to be unfinished and unclear...
Next, I will slowly talk about these places in a few articles :)
—
The first appearance "Haruno Haruno Shawl"
You read that right, the shawl that was just finished this year, I immediately washed her (super painful), I paid attention to all the cleaning (I have had too much experience of misplacing lotion in the past when I was too drowsy), but in a small step, because of the wrong step, the shawl was partially felt (holding a headache and crying)
This small mistake is that after pouring cold water into neutral lotion, "not stirring sufficiently", and then directly putting the shawl down
Because not the entire shawl is felted, but part by piece, I realized how important it is to not mix the lotion with water first!
Again, I was really careless, thinking that the shawl was made of thread - Aestiva has 30% French linen, plus it is made in a semi-worsted way, in theory, it should not pay special attention to the risk of felting like 100% woolen and woolen-spun wire, but in fact, the wire still has up to 70% Abruzzese wool, and the semi-worsted way, the arrangement of wool fibers is still free and random, uncombed, Therefore, it still retains the characteristics of wool spinning and containing air, so clean the water, in addition to using "cleaning products" with caution, every small step should not be careless!
And the result of feltization is that the beautiful lines are pasted into one piece (beating the heart and liver)
In addition, about the weaving of Haruno shawls, it is also necessary to remind again, although shawls are usually less need to worry about "weaving density" items, can be casual, basically Haruno is also, but Aestiva is a high proportion of animal hair wool twine, at the beginning of the weaving will be misled by the touch of flax fibers, thinking that the wire is very thin, but after entering the water, the wool fibers will bloom a lot and become fluffy, plus Haruno has a large number of twisted needles, lace patterns, if the density is too dense, After the water is set, the three-dimensional pattern will not be three-dimensional and distinct
Therefore, it is recommended that people with tight hands relax the force, or directly take a larger needle to knit, a little hollow feeling, but after entering the water, the texture will be highlighted and better!
(Weavers who are going to weave Sunweavers shawls should also pay attention to this, and Inese is also very careful to emphasize this in the weaving diagram)
The above is a painful lesson 1, yes... I have many examples of mistakes, and I will tell them later
--
Original text on Facebook